Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Remove the front wheel & tire.
Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
Loosen the hose eyebolt (B) and caliper mounting bolts (C), then remove the front caliper assembly (A).
Tightening torque:

Brake hose to caliper (B):

24.5 ~ 29.4 N.m (2.5 ~ 3.0 kgf.m, 18.1 ~ 21.7 lb-ft)

Caliper assembly to knuckle (C):

78.5 ~ 98.1 N.m (8.0 ~ 10.0 kgf.m, 57.9 ~ 72.3 lb-ft)

Fig 1: Identifying Hose Eyebolt, Caliper Mounting Bolts And Front Caliper Assembly
Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: Do not loosen the bolts (E) instead of guide rod bolt.
Remove the front brake disc by loosening the screws (A).

Fig 2: Identifying Front Brake Disc Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA