Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Turn ignition switch OFF and disconnect the negative (-) battery cable.
Remove the crash pad lower panel and reinforcing panel.
(Refer to "CRASH PAD ")
Remove the shower duct.
Disconnect the stop lamp switch connector, and then remove the stop lamp switch (A).

Fig 1: Identifying Stop Lamp Switch
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the brake pedal sensor connector (A).

Fig 2: Identifying Brake Pedal Sensor Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the brake pedal member mounting nut (B).
Tightening torque: 9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)

Fig 3: Identifying Brake Pedal Member Mounting Nut
Courtesy of HYUNDAI MOTOR AMERICA
Remove the snap pin (A) and clevis pin (B).

Fig 4: Identifying Snap Pin And Clevis Pin
Courtesy of HYUNDAI MOTOR AMERICA
Remove the brake pedal member assembly mounting nuts and then remove the brake pedal assembly.
Tightening torque: 12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)

Fig 5: Identifying Brake Pedal Member Assembly Mounting Nuts
Courtesy of HYUNDAI MOTOR AMERICA