Stop Lamp Switch Clearance Adjustment

If the gap between stop lamp switch and bracket is not 1.0~2.0 mm (0.04~0.08 in), adjust as described below.

1. Disconnect the stop lamp switch connector (B).
   Fig 1: Identifying Stop Lamp Switch Connector

   Courtesy of HYUNDAI MOTOR AMERICA
2. Pull the locking plate (A) as indicated by the arrow shown in illustration.
   Fig 2: Pulling Locking Plate

   Courtesy of HYUNDAI MOTOR AMERICA
3. Turn stop lamp switch 45° counterclockwise and remove it.
   Fig 3: Turning Stop Lamp Switch Counterclockwise

   Courtesy of HYUNDAI MOTOR AMERICA
4. Fix the brake pedal arm and insert fully the stop lamp switch as hiding contact part.
   Fig 4: Positioning Stop Lamp Switch

   Courtesy of HYUNDAI MOTOR AMERICA
5. After inserting, turn the stop lamp switch (A) 45° clockwise, and then assemble locking plate (B) by pushing.
   Fig 5: Turning Stop Lamp Switch Clockwise & Assembling Locking Plate

   Courtesy of HYUNDAI MOTOR AMERICA
6. Confirm the gap between stop lamp switch and bracket.

   Stop lamp clearance:  1.0 ~ 2.0 mm (0.04 ~ 0.08 in.)

   Fig 6: Checking Gap Between Stop Lamp Switch And Bracket

   Courtesy of HYUNDAI MOTOR AMERICA
7. Connect the stop lamp switch connector.