LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2015 >> Sonata Eco >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 114 (Antilock Brake System/Electronic Stability Control System Diagnosis (HEV)) >> DTC C1235: Primary Pressure Sensor - Electrical >> Verification of Vehicle Repair >> Verification of Vehicle Repair

Verification of Vehicle Repair

WARNING: This page is about a different variant/trim than selected.

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and select "Diagnostic Trouble Codes (DTC) " mode
  2. Using a GDS, Clear DTC.
  3. Operate the vehicle within DTC Detecting Condition in GENERAL INFORMATION .
  4. Are any DTCs present?

    YES 

    • System performing to specification at this time. Clear the DTC

    NO 

    • Go to the applicable troubleshooting procedure.
scientia non olet · About LEMON Manuals