LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2015 >> Sonata Eco >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 108 (Airbag Modules & Clock Spring (HEV)) >> Driver Airbag (DAB) Module and Clock Spring >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  2. Remove the driver airbag module from the steering wheel after pressing the snap fit pin stopper.
    Fig 1: Press Snap Fit Pin Stopper
    G10589209Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the wiring fixing clip (C) and disconnect the horn connector (A).
    Fig 2: Identifying Wiring Fixing Clip And Horn Connector
    G10589210Courtesy of HYUNDAI MOTOR AMERICA
  4. Release the connector locking pin, then disconnect the driver airbag module connector (B).
    CAUTION: The removed airbag module should be stored in a clean, dry place with the pad cover facing up.
  5. Remove the steering wheel and steering wheel column shroud. (Refer to STEERING COLUMN AND SHAFT )
    Fig 3: Removing Steering Wheel Column Shroud
    G10589211Courtesy of HYUNDAI MOTOR AMERICA
  6. Disconnect the clock spring and horn connector, then remove the clock spring.
    Fig 4: Identifying Clock Spring
    G10589212Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals