Deploying airbags in the vehicle

If an SRS equipped vehicle is to be entirely scrapped, the airbags or side airbags should be deployed while still in the vehicle. The airbags or side airbags should not be considered as salvageable parts and should never be installed in another vehicle.

1. Turn the ignition switch OFF, and disconnect the battery negative cable and wait at least three minutes.
2. Confirm that each airbag or side airbag is securely mounted.
3. Confirm that the special tool is functioning properly by following the check procedure.
   1. Driver's Airbag:
      1. Remove the driver's airbag and install the SST (0957A-3Q100).
      2. Install the driver's airbag on the steering wheel.
   2. Front Passenger's Airbag:
      1. Remove the glove box housing, and then disconnect the connector between the front passenger's airbag and SRS main harness.
      2. Install the SST(0957A-2E110).
   3. Side Airbag:
      1. Disconnect the 2P connector between the side airbag and wire harness.
      2. Install the SST (0957A-3F100).
   4. Curtain Airbag:
      1. Disconnect the 2P connector between the curtain airbag and wire harness.
      2. Install the SST (0957A-3S100).
   5. Seat Belt Pretensioner:
      1. Disconnect the 2P connector from the seat belt pretensioner.
      2. Install the SST (0957A-3S100).
4. Place the deployment tool at least thirty feet (10 meters) away from the airbag.
5. Connect a 12 volt battery to the tool.
6. Push the tool's deployment switch. The airbag should deploy (deployment is both highly audible and visible: a loud noise and rapid inflation of the bag, followed by slow deflation)
7. Dispose of the complete airbag. No parts can be reused. Place it in a sturdy plastic bag and seal it securely.