Components and Components Location: Inspection: Removal

WARNING: This page is about a different variant/trim than selected.

Disconnect the negative (-) battery terminal.
Remove the steering wheel.
(Refer to the "STEERING COLUMN & SHAFT ")
Remove the steering column upper and lower shrouds after removing 3 screws.

Fig 1: Removing Steering Column Upper & Lower Shrouds
Courtesy of HYUNDAI MOTOR AMERICA
If it is necessary to remove the wiper & washer switch (A) only, release the lock of wiper switch using tool without removing the steering wheel and the clock spring.

Fig 2: Identifying Wiper And Washer Switch
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the lighting switch connector (A) and wiper & washer switch connector (B).

Fig 3: Disconnecting Lighting Switch Connector
Courtesy of HYUNDAI MOTOR AMERICA

Fig 4: Identifying Wiper & Washer Switch Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the steering wheel.
(Refer to the "STEERING COLUMN & SHAFT ")
Remove the clock spring.
(Refer to the "AIRBAG MODULE ")
Remove the multifunction switch assembly (A) after loosening the mounting screws.

Fig 5: Removing Multifunction Switch Assembly
Courtesy of HYUNDAI MOTOR AMERICA