Repair Procedures: Removal

Information 

• In order to remove rear glass, use tools as follows shown in the illustration.

  [Tools block diagram] 

  Fig 1: Identifying Square Wire And Insert Type Grip

  Courtesy of HYUNDAI MOTOR AMERICA

  (1) Square wire

  (2) Insert type wire grip

  [Tools assembly diagram] 

• Tighten square wire (1) inserting it in the hole of Insert type wire grip (2)
  Fig 2: Tightening Square Wire Inserting It Into Hole Of Wire Grip

  Courtesy of HYUNDAI MOTOR AMERICA

1. Remove movable glass.

   (Refer to "MOVABLE GLASS ")

2. Remove roof molding (A) using screw driver or remover.
   Fig 3: Identifying Roof Molding

   Courtesy of HYUNDAI MOTOR AMERICA
3. Cut sealant from front pulling square wire (A) from left to right.
   CAUTION:

   • Wear gloves not to get hurt in the hand.
   • Be careful not to be burned in the hand by too much heat using wire.
   • Work carefully because wire can be cut.
   • When cutting rear wire, be careful not to damage rear wind seal glass.
     Fig 4: Removing Sealant From Front Using Square Wire

     Courtesy of HYUNDAI MOTOR AMERICA
   NOTE:

   • Give attention not to damage body.
4. Carefully remove rear glass (A) not to be damaged.
   Fig 5: Identifying Rear Glass

   Courtesy of HYUNDAI MOTOR AMERICA