Manual Calibration
WARNING: This page is about a different variant/trim than selected.
- Move the vehicle from the large steel structure or electric power supply cable.
- Turn on the compass by pressing the A button.
- Check the zone number by pressing the A button for more than 4 seconds until the current zone number appears in the display.
To re-calibrate, hold the A button for 3 seconds until C is displayed. If the zone number is different for your country, set the correct zone number referring to "Setting the compass zone" and do the "calibration procedure" again.
- Drive your vehicle in at least 2 circles at less than 5 miles per hour (8 km/h) until the compass heading appears. Driving in a circle in right-handed direction and opposite direction is possible and if possible, stops the wiper operation.
- If the vehicle's compass headings become inaccurate as before, do the following procedure again.NOTE: If new vehicle is first driven or if the battery has been disconnected, do the calibration procedure as above.