Repair Procedures: Removal
WARNING: This page is about a different variant/trim than selected.
- Disconnect the negative (-) battery terminal.
- Remove the rear combination lamp cover (A).
- If necessary to remove the bulb, remove the bulb after removing rear combination cover.
[Turn Signal Lamp]
- Remove the rear combination lamp after loosening the mounting nuts (4 EA) and disconnecting the connector (A).
- Remove the trunk lid trim.
(Refer to the "TRUNK TRIM ")
- Replace the bulb after removing the trunk lid lamp assembly.
[Back Up Lamp]
- Remove the trunk lid lamp assembly (A) after loosening the mounting nuts (3 EA) and disconnecting the connector.