Repair Procedures: Inspection

WARNING: This page is about a different variant/trim than selected.

Disconnect the negative (-) battery terminal.
Remove the lighting switch of the multifunction switch. (Refer to the MULTIFUNCTION SWITCH - SONATA HEV article)
With the front fog lamp switch, make sure that continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function switch.

Fig 1: Identifying Front Fog Lamp Connector With Connector End View
Courtesy of HYUNDAI MOTOR AMERICA

Fig 2: Front Fog Lamp Terminals Continuity Chart
Courtesy of HYUNDAI MOTOR AMERICA