Repair Procedures: Replacement

WARNING: This page is about a different variant/trim than selected.

Disconnect the negative (-) battery terminal.
Remove the crash pad left side cover (A).

Fig 1: Identifying Crash Pad Left Side Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the extension cover.
(Refer to "CRASH PAD ")
Remove the crash pad lower cover (A).

Fig 2: Removing Crash Pad Lower Cover
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connector (A) and diagnosis connector (B) and then remove the crash pad lower cover.

Fig 3: Identifying Crash Pad Lower Cover Connector
Courtesy of HYUNDAI MOTOR AMERICA

Fig 4: Identifying Diagnosis Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the reinforcing panel (A).

Fig 5: Removing Reinforcing Panel
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shower duct (A).

Fig 6: Removing Shower Duct
Courtesy of HYUNDAI MOTOR AMERICA
Remove the BCM (A).

Fig 7: Removing BCM
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the temperature control actuator connector (A).
Loosen the mounting screw and then remove the temperature control actuator (B).
[Driver's side]

Fig 8: Removing Temperature Control Actuator Mounting Screw
Courtesy of HYUNDAI MOTOR AMERICA
Remove the right extension cover (A).

Fig 9: Removing Right Extension Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the crash pad lower cover (A).

Fig 10: Removing Crash Pad Lower Cover
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connector (A) and then remove the crash pad lower cover.

Fig 11: Identifying Crash Pad Lower Cover Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the crash pad garnish (A).

Fig 12: Removing Crash Pad Garnish
Courtesy of HYUNDAI MOTOR AMERICA
Remove the center fascia panel (A).

Fig 13: Removing Center Fascia Panel
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the damper (B) from the glove box (A) and then remove the glove box lift (C).

Fig 14: Disconnecting Damper From Glove Box
Courtesy of HYUNDAI MOTOR AMERICA

Fig 15: Identifying Glove Box Lift
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the pin (A), then remove the glove box (B).

Fig 16: Identifying Pin & Glove Box
Courtesy of HYUNDAI MOTOR AMERICA

Fig 17: Identifying Glove Box Pin
Courtesy of HYUNDAI MOTOR AMERICA
Remove the glove box housing (A).

Fig 18: Removing Glove Box Housing
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shower duct (A).

Fig 19: Removing Shower Duct
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the temperature control actuator connector (A).
Loosen the mounting screw and then remove the temperature control actuator (B).
[Passenger's side]

Fig 20: Identifying Temperature Control Actuator Connector & Actuator
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order or removal.