LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2015 >> Sonata Eco >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 100 (Heater System (HEV)) >> Mode Control Actuator >> Repair Procedures >> Replacement

Repair Procedures: Replacement

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the crash pad left side cover (A).
    Fig 1: Identifying Crash Pad Left Side Cover
    G10590548Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the extension cover.

    (Refer to "CRASH PAD ")

  4. Remove the crash pad lower cover (A).
    Fig 2: Removing Crash Pad Lower Cover
    G10590549Courtesy of HYUNDAI MOTOR AMERICA
  5. Disconnect the connectors (A) and diagnosis connectors (B) and then remove the crash pad lower cover.
    Fig 3: Identifying Crash Pad Lower Cover Connectors
    G10590550Courtesy of HYUNDAI MOTOR AMERICA
    Fig 4: Identifying Diagnosis Connectors
    G10590551Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the reinforcing panel (A).
    Fig 5: Removing Reinforcing Panel
    G10590552Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the left shower duct (A).
    Fig 6: Removing Left Shower Duct
    G10590553Courtesy of HYUNDAI MOTOR AMERICA
  8. Loosen the BCM mounting nut and then remove the BCM (A).
    Fig 7: Loosening BCM Mounting Nut
    G10590554Courtesy of HYUNDAI MOTOR AMERICA
  9. Disconnect the mode control actuator connector (A).
  10. Loosen the mounting screw and then remove the mode control actuator (B).
    Fig 8: Removing Mode Control Actuator Mounting Screw
    G10590555Courtesy of HYUNDAI MOTOR AMERICA
  11. Install in the reverse order or removal.
scientia non olet · About LEMON Manuals