Repair Procedures: Installation

Information

In order to mount the front glass, use the tools displayed in the following figure :
[Tooling Diagram]

Fig 1: Sealant Nozzle, Sealant Gun And Adhesive Sealant For Car Windows
Courtesy of HYUNDAI MOTOR AMERICA
1. Sealant nozzle.
2. Adhesive sealant for car windows.
3. Sealant gun.

Install the roof side molding.
Press panorama sunroof switch to fully close the movable glass.
Use a blade to cut Off residual sealant (A) around body panel.
Information
- When cutting Off the residual sealant around the body panel, make sure to leave about 2mm of sealant from the adhesive surface.
NOTE:
- Make sure that the body paint surface is not damaged at all.
- If it is damaged, apply paint or rust inhibitor for maintenance.
Fig 2: Cutting Off Residual Sealant With Blade
Courtesy of HYUNDAI MOTOR AMERICA
Use alcohol or an air gun to clean up the edges of the body panel and front glass.
Use a sealant gun to apply sealant (B) around body panel (A).
NOTE:
- When using a sealant gun to apply the sealant, make sure that the sealant is not cracked to prevent water leaks.
Fig 3: Applying Sealant Around Body Panel
Courtesy of HYUNDAI MOTOR AMERICA
Install the front glass (A) loosely on the body panel.

Fig 4: Installing Front Glass
Courtesy of HYUNDAI MOTOR AMERICA
Check step and gap before front glass (A) is fully mounted.
Apply tape to around the front glass to prevent the glass from coming Off.
NOTE:
- If sealant is excessively applied, it may ooze out of the body. Use alcohol or a cleaning agent to wipe Off the residual sealant.
Fig 5: Checking Step And Gap
Courtesy of HYUNDAI MOTOR AMERICA

Information
- Mount front glass and set the car on a flat surface at least for 4 hours.
- If you have to drive the car, be sure to SLOWLY drive the car for at least 8 hours after mounting.
- Alert the driver to avoid driving the car aggressively for 2-3 days, or avoid driving it on irregular road surfaces.