Repair Procedures: Replacement

Remove the hole plug (B).
After loosening the mounting bolt, then remove the rear door outside handle cover (A).
Tightening Torque:

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

Fig 1: Identifying Hole Plug With Mounting Bolt
Courtesy of HYUNDAI MOTOR AMERICA

Fig 2: Identifying Rear Door Outside Handle Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the rear door outside handle (A) by sliding it rearward.

Fig 3: Removing Rear Door Outside Handle
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
Information
- Be sure to install the outside handle pad (A) onto between the outside handle and the door panel.
  
  Fig 4: Identifying Outside Handle Pad
  Courtesy of HYUNDAI MOTOR AMERICA
- Make sure the connector is connected properly.
- Make sure the door locks/unlocks and opens/closes properly.