Repair Procedures: Replacement

Remove the rear door module.
(Refer to: Rear Door - "REAR DOOR MODULE ").
Disconnect the rear door latch connector (A).

Fig 1: Identifying Rear Door Latch Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the rear door inside handle cage (A).

Fig 2: Identifying Rear Door Inside Handle Cage
Courtesy of HYUNDAI MOTOR AMERICA
Remove the rear door inside handle cable (A) by pushing it rearward.

Fig 3: Removing Rear Door Inside Handle Cable
Courtesy of HYUNDAI MOTOR AMERICA
Remove the rear door outside handle base (A) by pushing in the lock pins located in the back.

Fig 4: Identifying Rear Door Outside Handle Base
Courtesy of HYUNDAI MOTOR AMERICA
Remove the rear door outside handle cable (A).

Fig 5: Identifying Rear Door Outside Handle Cable
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
Information
- Make sure the connector is connected properly.
- Make sure the door locks/unlocks and opens/closes properly.
- Replace any damaged clips.