LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2015 >> Sonata Eco >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Rear Bumper (Except HEV) >> Rear Bumper Beam Assembly >> Repair Procedures >> Replacement

Repair Procedures: Replacement

CAUTION:
  • Put on gloves to protect your hands.
NOTE:
  • When prying with a flat-tip screwdriver, wrap it with protective tape and apply protective tape around the related parts to prevent damage.
  • Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
  • Take care not to bend or scratch the trim and panels.
  1. Remove the rear bumper cover.

    (Refer to: Rear Bumper - "REAR BUMPER COVER ").

  2. After loosening the mounting clips, then remove the rear bumper center under cover (A).
    Fig 1: Rear Bumper Center Under Cover With Mounting Clips
    G10565971Courtesy of HYUNDAI MOTOR AMERICA
  3. Disconnect the rear bumper beam mounting wiring harness.
  4. Remove the mounting clips (A), then remove the rear bumper beam assembly (B).
    Fig 2: Rear Bumper Beam Assembly And Mounting Clips
    G10565972Courtesy of HYUNDAI MOTOR AMERICA
  5. Install in the reverse order of removal.

    Information 

    • Make sure the connector is connected properly.
    • Replace any damage clips.
scientia non olet · About LEMON Manuals