Repair Procedures: Replacement

CAUTION:

NOTE:

When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape and apply protective tape around the related parts to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.

Loosen the front bumper upper mounting clips.

Fig 1: Front Bumper Upper Mounting Clips
Courtesy of HYUNDAI MOTOR AMERICA
Loosen the front bumper lower mounting clips.

Fig 2: Front Bumper Lower Mounting Clips
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the front bumper (A) side mounting clips and screw, then disconnect the sides.
Information
- Remove the front bumper by pulling up the side of the front bumper and then pull it out.
CAUTION:
- When you pull out the front bumper, the side part of the front bumper could be damaged by the projection.
Fig 3: Front Bumper With Mounting Clips And Screw
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the front bumper main connector (A).

Fig 4: Identifying Front Bumper Main Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the front bumper cover (A).

Fig 5: Front Bumper Cover
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
Information
- Make sure the connector is connected properly.
- Replace any damage clips.