Reclining Motor Limit Switch

NOTE: The power seat motor (IMS Specification) mounted in this vehicle uses the hole sensor to calculate the maximum operation distance, so it DOES NOT require limit switch.
But, NON-IMS specification driver seat and passenger seat have limit switches in the motor in the back of the chairs.

Disconnect the limit switch and operate the limit switch.
Check for continuity between the terminals.
Make sure that the seat operation is normal in the reverse after the maximum operation.
If there is an abnormality, replace the limit switch.

Fig 1: Identifying Reclining Motor Limit Switch Terminals
Courtesy of HYUNDAI MOTOR AMERICA

Fig 2: Reclining Motor Limit Switch Continuity Chart
Courtesy of HYUNDAI MOTOR AMERICA