Repair Procedures: Replacement

CAUTION:

NOTE:

When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.

Remove the rear seat cushion assembly.
(Refer to: Rear Seat - "REAR SEAT ASSEMBLY ").
After loosening the mounting screws, then remove the rear isofix bracket (A).

Fig 1: Identifying Rear Isofix Bracket With Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
After removing the clips on the rear of seat cushion cover and remove the rear seat cushion cover (A).
[Front Side]

Fig 2: Identifying Rear Seat Cushion Cover - Front Side
Courtesy of HYUNDAI MOTOR AMERICA

[Rear Side]

Fig 3: Identifying Rear Seat Cushion Cover - Rear Side
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
Information
- To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the clips (A).
- Replace the Hog-Ring Clips with new ones using Special Tool (C) (09880-4F000).
  
  Fig 4: Replacing Hog-Ring Clips Using Special Tool (09880-4F000)
  Courtesy of HYUNDAI MOTOR AMERICA