Repair Procedures: Replacement
CAUTION:
- Put on gloves to protect your hands.
NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape and apply protective tape around the related parts to prevent damage.
- Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
- Take care NOT to bend or scratch the trim and panels.
- Using a screwdriver or remover, remove the crash pad under cover [RH] (A).
- Disconnect the under lamp connector (A).
- Install in the reverse order of removal.
Information
- Make sure the connector is connected properly.
- Replace any damaged clips.