Repair Procedures: Replacement

CAUTION:

NOTE:

When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape and apply protective tape around the related parts to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.

Remove the cowl side trim.
(Refer to: Interior Trim - "COWL SIDE TRIM ").
Using a screwdriver or remover, remove the crash pad side cover [LH] (A).

Fig 1: Removing Crash Pad Side Cover (LH) Using Screwdriver Or Remover
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the crash pad lower panel (A).

Fig 2: Crash Pad Lower Panel With Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the diagnosis connector (A) and various connectors (B).

Fig 3: Identifying Diagnosis Connector And Various Connector
Courtesy of HYUNDAI MOTOR AMERICA

Fig 4: Identifying Various Connectors
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
Information
- Make sure the connector is connected properly.
- Replace any damaged clips.