Repair Procedures: Replacement

NOTE:

When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape and apply protective tape around the related parts to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care NOT to bend or scratch the trim and panels.

Using a screwdriver or remover, remove the crash pad side cover [RH] (A).

Fig 1: Removing Crash Pad Side Cover (RH) Using Screwdriver Or Remover
Courtesy of HYUNDAI MOTOR AMERICA
After loosen the mounting screws, remove the crash pad passenger side garnish (A).

Fig 2: Crash Pad Passenger Side Garnish With Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screw, then remove the crash pad garnish assembly [RH] (A).

Fig 3: Crash Pad Garnish Assembly With Mounting Screws (RH)
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
Information
- Replace any damaged clips.