Repair Procedures: Replacement

CAUTION:

NOTE:

When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape and apply protective tape around the related parts to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care NOT to bend or scratch the trim and panels.

Using a screwdriver or remover, remove the center facia lower panel assembly (A).

Fig 1: Removing Center Facia Lower Panel Assembly Using Screwdriver Or Remover
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the A/C & heater controller connectors (A).

Fig 2: Identifying A/C & Heater Controller Connectors
Courtesy of HYUNDAI MOTOR AMERICA
Lower the steering wheel.
Using a screwdriver or remover, remove the steering column shroud upper panel (A).

Fig 3: Steering Column Shroud Upper Panel
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the cluster facia upper panel assembly (A).

Fig 4: Removing Cluster Facia Upper Panel Assembly Using Screwdriver Or Remover
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screw, then remove the center facia upper panel assembly (A).

Fig 5: Center Facia Upper Panel Assembly With Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
Information
- Replace any damaged clips.