■ Check Open in Subwoofer Signal Circuit
- IG Key "OFF.
- Disconnect "AMP" connector and "WOOFER SPEAKER" connector.
- Measure the resistance between "Woofer Speaker 2 (+)" terminal of "AMP" harness connector and (+) terminal of "WOOFER SPEAKER" harness connector.
- Measure the resistance between "Woofer Speaker 2 (-)" terminal of "AMP" harness connector and (-) terminal of "WOOFER SPEAKER" harness connector.
Specification: Continuity (below 1.0)
- Is the measured resistance within the specification?
YES
- Go to: "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Repair open in "WOOFER SPEAKER" signal circuit.
- Go to: "VERIFICATION OF VEHICLE REPAIR " procedure.