■ Check Open in Center Speaker Signal Circuit
- IG Key "OFF.
- Disconnect "AMP" connector and "CENTER SPEAKER" connector.
- Measure the resistance between "CTR (+)" terminal of "AMP" harness connector and (+) terminal of "CENTER SPEAKER" harness connector.
- Measure the resistance between "CTR (-)" terminal of "AMP" harness connector and (-) terminal of "CENTER SPEAKER" harness connector.
Specification: Continuity (below 1.0)
- Is the measured resistance within the specification?
YES
- Go to: "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Repair open in "CENTER SPEAKER" signal circuit.
- Go to: "VERIFICATION OF VEHICLE REPAIR " procedure.