■ Check Open in F/L Mid Range Speaker Signal Circuit

IG key "OFF.
Disconnect "AMP" connector and "FRONT MID RANGE SPEAKER LH" connector.
Measure the resistance between "MID FL (+)" terminal of "AMP" harness connector and (+) terminal of "FRONT MID RANGE SPEAKER LH" harness connector.
Measure the resistance between "MID FL (-)" terminal of "AMP" harness connector and (-) terminal of "FRONT MID RANGE SPEAKER LH" harness connector.
Specification: Continuity (below 1.0)
Is the measured resistance within the specification?
YES
- Go to: "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Repair open in "FRONT MID RANGE SPEAKER LH" signal circuit.
- Go to: "VERIFICATION OF VEHICLE REPAIR " procedure.