Signal Circuit Inspection

Check Open in F/L Woofer Signal Circuit
1. IG key "OFF.
2. Disconnect "AMP" connector and "DRIVER DOOR SPEAKER" connector.
3. Measure the resistance between "FL (+)" terminal of "AMP" harness connector and (+) terminal of "DRIVER DOOR SPEAKER" harness connector.
4. Measure the resistance between "FL (-)" terminal of "AMP" harness connector and (-) terminal of "DRIVER DOOR SPEAKER" harness connector.
  Specification: Continuity (below 1.0)
5. Is the measured resistance within the specification?
  YES
  - Go to: "VERIFICATION OF VEHICLE REPAIR " procedure.
  NO
  - Repair open in "DRIVER DOOR SPEAKER" signal circuit.
  - Go to: "VERIFICATION OF VEHICLE REPAIR " procedure.