LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2015 >> Sonata Eco >> Repair and Diagnosis >> Accessories & Equipment >> Collision/Avoidance >> Blind Spot Detection Diagnosis - Right (Except HEV) >> DTC C170D-04: ECU Hardware Error (REAR RIGHT) >> DTC Inspection >> Monitor GDS Data

Monitor GDS Data

  1. Connect GDS to Data Link Connector (DLC).
  2. IG Key "ON", Engine "ON".
  3. Monitor Diagnostic Trouble Code and present of trouble code.
  4. Are any DTC's present?

    Using a GDS, Check if the same DTC re-sets after clearing DTC.

  5. Is the same DTC detected again?

    YES 

    • Substitute with a known-good "BSD ECU (RH)" and check for proper operation. If the problem is corrected, replace "BSD ECU (RH)" and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals