LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2015 >> Sonata Eco >> Repair and Diagnosis >> Accessories & Equipment >> Collision/Avoidance >> Blind Spot Detection Diagnosis - Right (Except HEV) >> DTC C170B-12: Activation Switch LED Circuit Short to Battery or Open >> DTC Inspection >> Monitor GDS Data

Monitor GDS Data

  1. Connect GDS to Data Link Connector (DLC).
  2. IG key "ON" -> "ON".
  3. Monitor Diagnostic Trouble Code and present of trouble code.
  4. Are any DTC's present?

    Using a GDS, Check if the same DTC re-sets after clearing DTC.

  5. Is the same DTC detected again?

    YES 

    • Continue to next procedure.

    NO 

    • Fault is intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and BSD ECU memory is not cleared yet. Thoroughly check all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration and/or damage.
    • Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals