LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2015 >> Sonata Eco >> Repair and Diagnosis >> Accessories & Equipment >> Collision/Avoidance >> Blind Spot Detection Diagnosis - Right (Except HEV) >> DTC C1613-81: CAN Signal Error EMS >> DTC Inspection >> Monitor GDS Data

Monitor GDS Data

  1. Connect GDS to Data Link Connector (DLC).
  2. IGN "ON".
  3. Using GDS, check if there is an error in Engine or EMS system.

    If there is an error in Engine or EMS system, first do a troubleshooting for those system and then check BSD system.

  4. Are any DTC's present?

    YES 

    • Substitute with a known-good "EMS" and check for proper operation. If the problem is corrected, replace "EMS" and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals