LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2015 >> Equus Ultimate >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Crash Pad >> Center Fascia Panel >> Repair procedures >> Replacement >> [Center Fascia Lower Tray]

[Center Fascia Lower Tray]

CAUTION:
  • Put on gloves to protect your hands.
NOTE:
  • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
  • Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
  • Take care not to bend or scratch the trim and panels.
  1. Remove the center fascia upper panel.

    (Refer to "CENTER FASCIA PANEL ")

  2. Remove the center fascia lower panel.

    (Refer to "CENTER FASCIA PANEL ")

  3. Remove the front console upper complete.

    (Refer to "FLOOR CONSOLE ASSEMBLY ")

  4. Remove the E-Shifter assembly.

    (Refer to "SHIFT LEVER ")

  5. Loosen the mounting screws, remove the center fascia lower tray (A).
    6. Fig 1: Center Fascia Lower Tray And Mounting Screws
    G10386598Courtesy of HYUNDAI MOTOR AMERICA
  6. Disconnect the lighting connector (A) and USB connector (B) and antenna (C).
    Fig 2: Antenna, Lighting Connecto And USB Connectors
    G10386599Courtesy of HYUNDAI MOTOR AMERICA
  7. Install in the reverse order of removal.
    IMPORTANT:
    • Make sure the connector is connected properly.
    • Replace any damage clips.
scientia non olet · About LEMON Manuals