Repair procedures: Removal

CAUTION:

Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
Avoid breathing dust particles.
Never use an air hose or brush to clean brake assemblies.

Release the parking brake.
Remove the rear wheel & tire.
Tightening torque:

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
Remove the rear brake drum (A).

Fig 1: Rear Brake Drum
Courtesy of HYUNDAI MOTOR AMERICA
Remove the upper return spring (A).

Fig 2: Upper Return Spring
Courtesy of HYUNDAI MOTOR AMERICA
Remove the lower return spring (A).

Fig 3: Lower Return Spring
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shoe hold springs (A) and shoe hold pins (B) and then remove brake shoe (C). Make sure not to damage the dust cover on the wheel cylinder.

Fig 4: Brake Shoes, Shoe Hold Springs And Pins
Courtesy of HYUNDAI MOTOR AMERICA
Remove the parking brake cable (A) and then remove brake shoe (B).

Fig 5: Parking Brake Cable And Brake Shoe
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect brake tubes (A) from the wheel cylinder (B).

Fig 6: Wheel Cylinder Brake Tubes
Courtesy of HYUNDAI MOTOR AMERICA
Remove the bolts (C) and the wheel cylinder (B) from the backing plate (D).