Repair procedures: Installation

NOTE:

Do not spill brake fluid on the vehicle: it may damage the paint; if brake fluid does contact the paint. Wash it off immediately with water.
To prevent spills, cover the hose joints with rags or shop towels.
Use only a genuine wheel cylinder special bolt.

Apply sealant (C) between the wheel cylinder (B) and backing plate (D), and install the wheel cylinder.

Fig 1: Wheel Cylinder Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Connect the brake tubes (A) to the wheel cylinder.
Tightening torque:

12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)
Connect the parking brake cable (A) to the brake shoe.

Fig 2: Parking Brake Cable And Brake Shoe
Courtesy of HYUNDAI MOTOR AMERICA
Install the brake shoes (C) onto the backing plate. Be careful not to damage the wheel cylinder dust covers.

Fig 3: Backing Plate Brake Shoes, Hold Down Pins And Springs
Courtesy of HYUNDAI MOTOR AMERICA
Install the shoe hold down pins (B) and the shoe hold down springs (A).
Clean the threaded portions of adjuster sleeve (A) and push rod female (B). Coat the threads of the adjuster assembly with grease. To shorten the clevises, turn the adjuster bolt (C).

Fig 4: Adjuster Rod Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Hook the shoe adjuster lever (C), then install it to the brake shoe.

Fig 5: Shoe Adjuster Lever
Courtesy of HYUNDAI MOTOR AMERICA
Install the adjuster assembly (B) and upper return spring (A) as right direction. Be careful not to damage the wheel cylinder dust covers.

Fig 6: Adjuster Assembly And Upper Return Spring
Courtesy of HYUNDAI MOTOR AMERICA
Install the lower return spring (B).

Fig 7: Lower Return Spring
Courtesy of HYUNDAI MOTOR AMERICA
Apply brake cylinder grease or equivalent rubber grease to the sliding surfaces shown. Don't get grease on the brake linings.

Fig 8: Grease Application Areas (1 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA
Apply brake cylinder grease or equivalent rubber grease to the brake shoe ends and opposite edges of the shoes shown. Don't get grease on the brake linings.

Fig 9: Grease Application Areas (2 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA
Install the rear brake drum (A).
Tightening torque:

4.9 ~ 5.9 N.m (0.5 ~ 0.6 kgf.m, 3.6 ~ 4.3 lb-ft)

Fig 10: Rear Brake Drum
Courtesy of HYUNDAI MOTOR AMERICA
If the wheel cylinder has been removed, bleed the brake system.
Depress the brake pedal several times to set the self-adjusting brake.
Adjust the parking brake.