LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2015 >> Elantra Sport, Automatic Trans >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brake & Drum Brake System >> Brake Pedal >> Repair procedures >> Removal

Repair procedures: Removal

  1. Turn ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the crash pad lower panel.

    (Refer to "CRASH PAD ")

  3. Remove the shower duct (A).
    Fig 1: Removing Shower Duct
    G10530632Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the stop lamp switch connector (A), and than remove stop lamp switch.
    Fig 2: Stop Lamp Switch Connector
    G10530633Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the brake pedal member mounting bolt (A).
  6. Remove the snap pin (A) and clevis pin (B).
    Fig 3: Snap And Clevis Pins
    G10530634Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the brake pedal member assembly mounting nuts and then remove the brake pedal assembly.
    Fig 4: Brake Pedal Member Assembly Mounting Nuts
    G10530635Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals