Repair procedures: Installation

Pre-tighten the bracket fixing bolt (A) in dash panel.

Fig 1: Bracket Fixing Bolt
Courtesy of HYUNDAI MOTOR AMERICA
Install the brake booster and brake pedal member fixing nuts (A) securely.
Tightening torque:

16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

Fig 2: Brake Pedal Member Fixing Nuts
Courtesy of HYUNDAI MOTOR AMERICA
Tighten the bolt (A) securely in dash panel.
Tightening torque:

16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

Fig 3: Dash Panel Bolt
Courtesy of HYUNDAI MOTOR AMERICA
Install the snap pin (A) and clevis pin (B).

Fig 4: Snap And Clevis Pins
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- Before installing the pin, apply the grease to the clevis pin.
- Use a new snap pin whenever installing.
Install the stop lamp switch securely.
Connect the stop lamp switch connector (A).

Fig 5: Stop Lamp Switch Connector
Courtesy of HYUNDAI MOTOR AMERICA
Adjust the brake pedal height and free play.
Check the brake pedal operation after installing the brake pedal.
Install the shower duct (A).

Fig 6: Installing Shower Duct
Courtesy of HYUNDAI MOTOR AMERICA
Install the crash pad lower panel.
Reconnect the battery negative cable.