Repair procedures: Installation

Installation is the reverse of removal.
CAUTION: Use a new washer (A) whenever installing.

Fig 1: Washer
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
When installing the RH rear brake hose, the brake tube must not be touched to the tire.
1. Without the brake tube fixing clip
  - When tightening the brake tube flare nut (A), tighten it with a specified torque by pushing it toward the car body not to damage to the brake tube (B).
    Tightening torque:
    
    12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)
    
    Fig 2: Brake Tube Flare Nut
    Courtesy of HYUNDAI MOTOR AMERICA
  - After installation, check that the brake tube must not be touched to the tire.
2. With the brake tube fixing clip
  - Insert the brake fixing clip (B) to the end after fixing the brake tube to the brake tube fixing clip (B).
    
    Fig 3: Brake Tube Fixing Clip
    Courtesy of HYUNDAI MOTOR AMERICA
  - Tighten the brake tube flare nut (A) with a specified torque.
    Tightening torque:
    
    12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)
    
    Check again that the brake tube fixing clip (B) must be fixed in place.
After installation, bleed the brake system.
(Refer to "BRAKE SYSTEM BLEEDING ")
Check the spilled brake oil.