Repair Procedures: Removal

NOTE:

Remove the following items.
- Front pillar trim
  (Refer to "INTERIOR TRIM ")
- ECM mirror
  (Refer to "MIRROR ")
- Rain sensor
  (Refer to Procedures found in "ROOF TRIM REPLACEMENT ")
- Auto defog sensor.
  (Refer to "AUTO DEFOGGING SENSOR ")
- Windshield wiper arm
  (Refer to "COWL TOP COVER ")
- Cowl top cover
  (Refer to "COWL TOP COVER ")
Cut out the adhesive using a cutter (A).
Information
- Please use a cutter with a blade length between 8-12 inches.
  
  Fig 1: Cutting Out Adhesive Using Cutter
  Courtesy of HYUNDAI MOTOR AMERICA
Cut off the sealant on the edge (B) while pulling the piano wire (A) left and right.

Fig 2: Sealant Cutting Position On Edges
Courtesy of HYUNDAI MOTOR AMERICA
If a piano wire is visible inside the chassis, pull the piano wire (A) line inside.

Fig 3: Pulling Piano Wire
Courtesy of HYUNDAI MOTOR AMERICA
Cut off the sealant on (A-A), (B-B), (C-C), while pulling a piano wire (A) left and right.
CAUTION:
- Put on gloves to protect your hands.
- Heat may occur when working on the wires. Be careful not to burn your hands.
- Be careful not to disconnect the piano wire.
Fig 4: Cutting Off Sealant
Courtesy of HYUNDAI MOTOR AMERICA
Remove the windshield glass (B) carefully using the glass holder (A).

Fig 5: Removing Windshield Glass Using Glass Holder
Courtesy of HYUNDAI MOTOR AMERICA