Roof Trim Replacement

CAUTION:

Put on gloves to protect your hands.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.

Remove the following items:
1. Front seat
  (Refer to "FRONT SEAT ")
2. Rear seat
  (Refer to "REAR SEAT ")
3. Floor console
  (Refer to "CONSOLE ")
4. Sunvisor
5. Vanity lamp
6. Room lamp
7. Assist handle
8. Overhead console
9. Front pillar trim
  (Refer to "INTERIOR TRIM ")
10. Front door scuff trim & Rear door scuff trim
  (Refer to "INTERIOR TRIM ")
11. Canter pillar lower trim
  (Refer to "INTERIOR TRIM ")
12. Canter pillar upper trim
  (Refer to "INTERIOR TRIM ")
13. Wheel house trim
  (Refer to "INTERIOR TRIM ")
14. Rear pillar trim
  (Refer to "INTERIOR TRIM ")
Remove the ECM mirror cover (A).
Disconnect the ECM mirror connector (B).

Fig 1: ECM Mirror Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the auto defog sensor cover (A).
Disconnect the auto defog sensor connector (B).

Fig 2: Auto Defog Sensor Cover And Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the rain sensor cover (A).
Disconnect the rain sensor connector (B).

Fig 3: Rain Sensor Cover And Connector
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the roof trim main connector (A).

Fig 4: Roof Trim Main Connector
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the sunroof motor connector (A).

Fig 5: Sunroof Motor Connector
Courtesy of HYUNDAI MOTOR AMERICA
Detach the clips, then remove the roof trim (A).

Fig 6: Roof Trim With Clips
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
NOTE:
- Replace any damaged clips.
- Make sure the connector is plugged in properly.