Package Tray Trim Replacement

CAUTION:

Put on gloves to protect your hands.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.

Remove the rear seat assembly.
(Refer to "REAR SEAT ")
Remove the rear door scuff trim.
Using a screwdriver or remover, remove the rear pillar trim (A).

Fig 1: Rear Pillar Trim
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws and clips, then remove the luggage partition trim (A).

Fig 2: Luggage Partition Trim With Mounting Screws And Clips
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the rear wheel house trim (A).

Fig 3: Rear Wheel House Trim
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connector (A).

Fig 4: Rear Wheel House Trim Connector
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the package tray trim (A).

Fig 5: Package Tray Trim
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
NOTE:
- Replace any damaged clips.
- Make sure the connector is connected properly.