Roof Trim Replacement
NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.
- Remove the front seat assembly. (Refer to "FRONT SEAT ")
- Remove the rear seat assembly. (Refer to "REAR SEAT ")
- Remove the sunvisor and retainer.
- Remove the overhead console.
- Remove the assist handle.
- Remove the garment hook assembly.
- Remove the front pillar trim. (Refer to "INTERIOR TRIM ")
- Remove the front door scuff trim. (Refer to "INTERIOR TRIM ")
- Remove the rear door scuff trim. (Refer to "INTERIOR TRIM ")
- Remove the center pillar lower trim. (Refer to "INTERIOR TRIM ")
- Remove the center pillar upper trim. (Refer to "INTERIOR TRIM ")
- Remove the rear pillar trim. (Refer to "INTERIOR TRIM ")
- Remove the ECM mirror cover (B).
- Disconnect the ECM mirror connector (A).
- Remove the auto defog sensor cover (B).
- Disconnect the auto defog sensor connector (A).
- Disconnect the connector (A) and the mounting clips in the front pillar.
- Remove the clips and roof trim (A).
- Installation is the reverse of removal.
NOTE:
- Make sure the connectors are plugged in properly.
- Replace any damage clips.