LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2014 >> Equus Ultimate >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Crash Pad >> Center Fascia Panel >> Repair procedures >> Replacement >> [Center Fascia Lower Tray]

[Center Fascia Lower Tray]

CAUTION:
  • Put on gloves to protect your hands.
NOTE:
  • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
  • Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
  • Take care not to bend or scratch the trim and panels.
  1. Remove the center fascia upper panel.

    (Refer to CENTER FASCIA PANEL .

  2. Remove the center fascia lower panel.

    (Refer to "CENTER FASCIA PANEL ")

  3. Remove the front console upper complete.

    (Refer to "FLOOR CONSOLE ASSEMBLY ")

  4. Remove the E-Shifter assembly.

    (Refer to AUTOMATIC TRANSMISSION CONTROL SYSTEM ).

  5. Loosen the mounting screws, remove the center fascia lower tray (A).
    Fig 1: Identifying Center Fascia Lower Tray
    G09790567Courtesy of HYUNDAI MOTOR AMERICA
  6. Disconnect the lighting connector (A) and USB connector (B) and antenna (C).
    Fig 2: Identifying Lighting Connector And USB Connector And Antenna
    G09790568Courtesy of HYUNDAI MOTOR AMERICA
  7. Install in the reverse order of removal.

    Information 

    • Make sure the connector is connected properly.
    • Replace any damage clips.
scientia non olet · About LEMON Manuals