Repair procedures: Replacement

CAUTION:

NOTE:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.

Disconnect the stopper (B) from the glove box (A).

Fig 1: Identifying Glove Box And Stopper
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the air damper (A) from the glove box (B).

Fig 2: Disconnecting Air Damper From Glove Box
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the pins (A) and then remove the glove box (B).

Fig 3: Removing Glove Box
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the glove box housing (A).

Fig 4: Identifying Glove Box Housing Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the glove box lamp connector (A).

Fig 5: Identifying Glove Box Lamp Connector
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
Information
- Make sure the connector is connected properly.
- Replace any damage clips.