Repair procedures: Replacement

[LH]

CAUTION:

NOTE:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.

Remove the crash pad lower panel.
(Refer to CRASH PAD LOWER PANEL )
After loosening the mounting screw, then remove the crash pad under cover [LH] (A).

Fig 1: Identifying Crash Pad Under Cover Mounting Screw (LH)
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the under lamp and diagnosis connector (A).

Fig 2: Identifying Under Lamp And Diagnosis Connector
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the crash pad under cover (A).

Fig 3: Identifying Crash Pad Under Cover And Mounting Screw
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
Information
- Make sure the connector is connected properly.
- Replace any damage clips.

[RH]

CAUTION:

NOTE:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.

Remove the cowl side trim.
(Refer to "COWL SIDE TRIM ")
To remove the crash pad under cover [RH] (A), press both sides of the locking pin and then pull it down in the direction of the arrow.

Fig 4: Identifying Crash Pad Under Cover (RH)
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the under lamp connector (A).

Fig 5: Disconnecting Under Lamp Connector
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
Information
- Make sure the connector is connected properly.
- Replace any damage clips.