Repair procedures: Replacement

CAUTION:

NOTE:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.

Using a screwdriver or remover, remove the crash pad side cover [LH] (A).

Fig 1: Identifying Crash Pad Side Cover (LH)
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the crash pad lower panel (A).

Fig 2: Identifying Crash Pad Lower Panel
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the crash pad lower panel switch connector (A) and knee airbag (KAB) module connector (B).

Fig 3: Identifying Crash Pad Lower Panel Switch Connector And Knee Airbag Module Connector
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
Information
- Make sure the connector is connected properly.
- Replace any damage clips.