Center Fascia Panel Replacement

CAUTION:

When prying with a flat-up screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.

Remove the crash pad side cover.
Using a screwdriver or remover, remove the crash pad lower panel (A).

Fig 1: Identifying Crash Pad Lower Panel
Courtesy of HYUNDAI MOTOR AMERICA
Remove the center fascia panel (A).

Fig 2: Identifying Center Fascia Panel
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connectors (A).

Fig 3: Disconnecting Center Fascia Panel Connectors
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse the removal.
NOTE:
- Make sure the connector is plugged in properly.
- Replace any damage clips.