Monitor GDS Data

* REFERENCE* 

Perform the initializing after replace "Height sensor"

* Vehicle condition 

1. Park at lever land
2. Vehicle speed ≤ 5km/h
3. Engine r.p.m > 500rpm
4. Connect GDS
5. CAN communication is normal status
6. Battery voltage > 10.5V
7. Headlamp S/W ON, AFLS ON

   (1) Calibration

   Fig 1: Display - Select Calibration Screen

   Courtesy of HYUNDAI MOTOR AMERICA
   Fig 2: Display - Calibration Screen

   Courtesy of HYUNDAI MOTOR AMERICA

   (2) Clear "DTC"

   (3) Confirm the Headlamp movement through the Actuation Test

   Fig 3: Display - Actuation Test Screen

   Courtesy of HYUNDAI MOTOR AMERICA

   (4) Confirm the "DTC" and "Service data"

   Fig 4: Display - Engine ON - AFLS Current Data

   Courtesy of HYUNDAI MOTOR AMERICA

   Select the Calibration, refer to Fig 1.

   Calibration, refer to Fig 2.

   Actuation Test, refer to Fig 3.

   Engine "ON" - AFLS's current data, refer to Fig 4.

YES 

• Go to "VERIFICATION OF VEHICLE REPAIR " procedure.

NO 

• Substitute with a known - good AFLS ECU and check for proper operation. If the problem is corrected, replace AFLS ECU and go to "VERIFICATION OF VEHICLE REPAIR " procedure.