General Information: DTC Detecting Condition

Item	Detecting Condition	Possible Cause
DTC Strategy	Check Stop Switch "ON" by the voltage level (Below 2V) Check the vehicle speed signal from CLU (2MPH_3km/h) IGN ON	Check Stop Signal Input state (ON/OFF)
Enable Conditions	Button Start Vehicle (Option) Stop Switch: ON In case of no ESCL error Vehicle speed: above 2MPH (3km/h)
Threshold Value	Stop Signal Input ON: Below 2V Stop Signal Input OFF: Above 7V
Diagnostic Time	Stop Switch is "ON" for 10sec and above under IG ON and the vehicle speed is over 2MPH (3km/h).
DTC Erasing Time	IG OFF Stop Signal Input: OFF Vehicle speed: Below 2MPH (3km/h) (* DTC is erased immediately when the vehicle condition meet to 1 condition among above 3.)