LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2012 >> Genesis 5.0 R-Spec >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Head Lamp AFLS (Led) Diagnosis >> DTC B1905: Sensor Power Supply Fault >> Scantool Diagnostics >> Monitor GDS Data

Monitor GDS Data

  1. Connect GDS to data link connector (DLC).
  2. Engine "ON" and Head lamp "ON"
  3. Monitor the "Sensor angle front, Sensor angle rear" parameters on the GDS.

    Specification:  below -128 ~ +125 mm

    Fig 1: Display - Sensor Angle Front And Rear Current Data
    G08840292Courtesy of HYUNDAI MOTOR AMERICA

    Engine "ON" - AFLS's current data (Sensor angle front and Sensor angle rear), refer to Fig 1.

  4. Is parameter displayed within specifications?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or AFLS ECU's connector or was repaired and AFLS ECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure

    NO 

scientia non olet · About LEMON Manuals