LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2012 >> Genesis 5.0 R-Spec >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Head Lamp AFLS (Led) Diagnosis >> DTC B1308: Lamp Function Signal Fault >> Scantool Diagnostics >> Monitor GDS Data

Monitor GDS Data

  1. Connect GDS to data link connector (DLC). And Engine "ON".
  2. Monitor a DTC, if there is a DTC clear it and then check the "AFLS activation switch/button status".
  3. Check an output value after operating Auto light switch.

    Specification:  On status , on operating Auto light switch.

    Fig 1: Display - AFLS Activation Switch/Button Status Current Data
    G08840229Courtesy of HYUNDAI MOTOR AMERICA
  4. Is the measured value within specifications?

    YES 

    • Fault is intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and AFLS ECU memory is not cleared yet. Thoroughly check all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
    • Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals